1. Power up the machine with the belly switch.
2. Go to the back side of your monitor and remove the cover using a 5/32" hex key.
-2.png?width=244&height=262&name=image%20(1)-2.png)
Note: Depending on the model year, it will look like one of the two pictures below once removed.
-1.png?width=342&height=322&name=image%20(1)-1.png)
3. Navigate to the configuration page.
4. In the middle of the screen under "Bluetooth Controller" tap "Unpair" next to all listed addresses.
5. Turn the machine off via the belly switch.
6. Insert the Bluetooth BLE Dongle into the blue USB 3.0 port shown.
7. Power the machine back up and navigate to the configuration page.
8. In the middle of the screen under "Bluetooth Controller" if message reads “BLE dongle not connected via USB”, click “Attempt to connect”.
-1.png?width=688&height=390&name=image%20(2)-1.png)
9. On Bluetooth Controller:
Hold the “play” (▷) and “minus” (-) buttons simultaneously until blue light begins to flash.
10.
On touchscreen:
Under “Dongle Bluetooth Controllers”, click “pair” next to the controller MAC address. Wait for message reading “Connected and ready for use”.
.png?width=688&height=391&name=image%20(3).png)